Skip to the page
FenrisEarly access

Kill switch from boot.

While Fenris is on, nothing from your device, or from the devices behind your router, leaves outside the tunnel. Not while it connects, not after a crash, not during an upgrade.

Every deviceOn by default

The tunnel can’t be reachedThe tunnel is up
Without a kill switchLeaves directly, from your home address
With FenrisHeld back until the tunnel is back
With FenrisThrough the tunnel, from your server’s address
Fig. 1On wired networks you list, traffic can go direct instead, after 30 seconds without your server. Never on open Wi-Fi.

What happens

  1. The block goes up before the network does. On a router or a PC it holds from early boot, before anything can send.
  2. Only the tunnel to your server is let out. Everything else waits behind it.
  3. If the tunnel can’t be reached, traffic waits, and the app says so. The tray reads Holding traffic.
  4. Name lookups are forced into the tunnel. IPv6 goes through it when your server has IPv6, and is refused at once otherwise, so it never leaks.
  5. A crash or an upgrade leaves the block in place. It comes down only when you turn Fenris off.

What it costs

No tunnel, no internet, until it is back.

While your server is away
Traffic waits. Nothing loads until your server answers, a second server takes over, or you turn Fenris off.
One address
Websites see your server’s address for everything. Some banks and streaming services distrust addresses that belong to a hosting provider.
Going direct
A site you set to go direct leaves outside the tunnel. It gets no bonding, and the network it leaves by can see it.
Sign-in pages
A hotel’s sign-in page can’t load through the block. One device is let through to it, for up to 5 minutes.

Turn it on

It is on from the start. These open it where you choose.

ToCommand lineRouter UI and app
Turn the kill switch offfenris settings --kill-switch offSettings, When Fenris can’t connect
Let chosen sites go directfenris settings --direct-domains bank.exampleSettings, Direct, outside the tunnel
Let a device at home go directfenris settings --direct-devices 192.168.1.40Settings, Direct, outside the tunnel
Go direct while only one link worksfenris settings --direct-when-alone onSettings, Direct, outside the tunnel
Turn the tunnel off for nowfenris disconnectHome, the switch
Check each step to your serverfenris checkDiagnostics

Where to find it

Router UIHome. Protected, and through which server.

The appHome. On Android, the kill switch is the system’s own always-on VPN setting.

The trayConnected, Connecting, Holding traffic or Off.

The productThree of its own screens, with example data.

What it keeps

Nothing. The kill switch is a rule on your device. It records nothing and sends nothing.

Where it stops

When Fenris is off
Turn Fenris off and traffic leaves directly, as it did before. The app warns you when you do.
Networks you trust
On wired networks you list, traffic goes direct after 30 seconds without your server. Never on open Wi-Fi.
Past your server
It keeps traffic inside the tunnel. Past your server, traffic is as protected as the website makes it.
On Android
The kill switch there is Android’s always-on VPN setting, with “Block connections without VPN”. The app shows you where it is.